****PLEASE ALLOW 3 WEEKS FOR DELIVERY*****No wind turbine on the market is built in Alaska for Alaskan Weather. They receive some of the roughest winds in North America. It is not uncommon to see over 100mph gusts every winter. These turbines have a proven track record that can't be beat. Everything is overbuilt to exceed requirements for extreme conditions.
The units are available in 12 and 24 volt systems. Please specify voltage when ordering. Please note 48v is only available with two wind generators wired in series. Chassis is made out of 3/16" plate with 3/4" square tubing (very strong) and 1/8" plate for tail. Stainless hubs NO ONE!
All model scome with One Year warranty.
Other features include:
PMA has no brushes, very dependable!
True PMA we use specially designed n52 Industrial magnets with over 400lbs of pull force far exceeding any competition currently out there.
Comes with 5 T6 6061 Aluminum beawindhog blades.
Stainless ball bearing slip ring to keep wires from tangling.
beawindhog blades are by far the best blades in the business.
Fits on 1.5" schedule #80 pipe. This utilizes the first industrial 10 hardened Stainless Steel ball bearing mount with locking collar. This allows the turbine to turn into the wind at only 2mph of wind. More than 10 percent of power is lossed due to the turbine not turning all the way into the wind.
200,000 hours+ of rated bearing life. New bearings cost only $5.00
Stainless 5 blade hub double thick compared to the competition (1/4" hardened stainless hub)
All welded chassis with 12" square tail fin
3/16" plate chassis extra thick for commercial install
1/2" square iron tail stem all welded no bolting for installations of 20 years or more.
New alternator design with new blades allow for a perfectly silent turbine
Stainless Bolts and locking nuts built to last a lifetime!
Commercially wound stators are done by machine and then dipped and baked for over 5 hours with 5 separate layers of lacquer. No hand wound knock off or junk stators that won't last over a year because the windings fall into the rotor. These stators are made by a factory specifically for longevity and industrial use.
Entire unit is primered and then coated 3 layers deep of gold lacquer or other color if you choose. PMA's are coated in epoxy paint and will look nice for 50 years.
1/4" Hardened stainless steel hub is impacted onto the PMA so you never have to worry about it slipping or becoming loose over time
Permanent Magnet alternator for efficient power.
No electronics in alternator
3 Phase output allows power to get to controller more efficiently with less expensive wire
Stainless slip ring
1-15/16" cast iron greaseable bearing for mounting.
